User's Manual

Installation
BreezeNET BU-DS.11/RB-DS.11 2-3 User’s Guide
2.4 Installation Overview
Note: Outdoor units and antennas should be installed ONLY by experienced installation
professionals who are familiar with local building and safety codes and, wherever
applicable, are licensed by the appropriate government regulatory authorities.
Failure to do so may void the BreezeCOM product warranty and may expose the
end user or the service provider to legal and financial liabilities. BreezeCOM and
its resellers or distributors are not liable for injury, damage or violation of
regulations associated with the installation of outdoor units or antennas.
The typical installation scheme is depicted in Figure 2-1. The installation process
should follow these general steps:
1. Select appropriate locations for the Outdoor unit, the antenna (if using an optional
external antenna) and the Indoor unit.
2. Mount the Outdoor unit and the external antennas (optional). Connect the Outdoor
unit to the antenna if installing external antennas.
Note: The FCC 15.203 requirement prohibits the connection of external antennas with
standard N-type connectors. In order to meet this requirement, the external
antenna connectors provided on DS.11D models (with no integral antenna) are
non-standard, featuring left-handed (counter-clockwise) rotation.
3. Connect a ground cable between the Outdoor unit and an appropriate grounding
point.
4. Connect the Indoor-to-Outdoor cable to the Outdoor unit and route it to the
location selected for the Indoor unit. Assemble the enclosed connector on the
cable. Refer to Appendix B for instructions on preparing the Indoor-to-Outdoor
cable.
5. Mount the Indoor unit. Connect the Indoor-to-Outdoor cable to the Indoor unit
Radio port. Prepare the power cable and use it to connect the Indoor unit to the
AC mains.
6. Connect the Indoor unit Ethernet port to the user’s network/PC using an Ethernet
cable.
7. Align the antenna and verify connectivity with the Base Station.
Note: The Indoor unit should be connected to the power source only after it has been
connected to the Outdoor unit.