User's Manual

Installation
BreezeNET BU-DS.11/RB-DS.11 2-1 User’s Guide
2. INSTALLATION
2.1 Quick Start to Wireless Networking
Perform the following steps to configure a WLAN for the first time:
1. Physically connect the BU-DS.11/RB-DS.11 units to the Ethernet LAN. Make
sure they are switched on. The DS.11 wireless network will be up and running
immediately. If you are content with the default settings of the BU-DS.11/RB-
DS.11 units, you can stop right here. It is more likely however, that you want to
assign different radio frequencies to each BU-DS.11/RB-DS.11, or impose some
restrictions on the use of your wireless network.
2. To be able to manage the BU-DS.11/RB-DS.11 units via SNMP, each BU-
DS.11/RB-DS.11 needs a unique IP address. If you provide a DHCP or BOOTP
service on your LAN (and have sufficient free IP addresses available) this will be
taken care of automatically. If not, refer to Section 3.1.1 for further information
on assigning IP addresses.
3. Use the BreezeNET DS.11 Management utility, described in Chapter 3 of this
manual, to configure the network settings to reflect your configuration.
4. Select the radio channels of the BU-DS.11/RB-DS.11 units according to your cell
plan. See Section 3.1.5 for further information. Add descriptive information about
each unit for later reference.