User's Guide

Installing Accessories
BreezeNET BU-DS.11/RB-DS.11 6-1 User’s Guide
6. INSTALLING ACCESSORIES
This chapter introduces some of the accessories available for specific installations, and describes
how to install them.
6.1 RFS 122 Radio Frequency Splitter
The RFS 122 Radio Frequency Splitter is used to split the RF signal generated by a transmitter into
two signals. These signals are then sent to two different and independent antennas. The RFS 122
enables radio transmission using two directional antennas connected to the same port of the
BreezeNET DS.11 unit. Similarly, the splitter is used to combine two receiving antennas to one
antenna connector.
Before installing the RFS 122, configure the BreezeNET DS.11 unit using the DS.11 Management
utility to transmit through Antenna 2 only (see Section 3.1.5), and connect the RFS 122 to antenna
connector 2.