User's Guide

Installation
BreezeNET BU-DS.11/RB-DS.11 2-19 User’s Guide
2.8 Installing the Indoor Unit
According to the specific conditions of the installation, route the Indoor-to-Outdoor cable into the
building so that it conveniently reaches the Indoor unit to ensure minimal interference, leaving
some spare. The cable is supplied open ended at the side of the Indoor unit, to allow for
conveniently threading it into the building through a hole that is as small as possible. Assemble the
connector and cover plug supplied with the cable. Appendix B provides instructions on how to
assemble the connector on the Indoor-to-Outdoor cable.
1. Remove the wall mounting bracket clipped to the rear of the Indoor unit and mount the Indoor
unit on a wall as shown in Figure 2-6.
2. Connect the Indoor-to-Outdoor cable to the Radio connector, located on the front panel of the
Indoor unit shown in Figure 2-8. The Indoor-to-Outdoor cable should be connected to the unit
before it is connected to the mains power.
Figure 2-6. Wall Mounting the Indoor Unit