Manualshelf

User's Guide

ManualsBrandsAlvarion Technologies ManualsElectronicsBreezeNET BU-DS.11 & RB-DS.11
21222324252627282930
Installation
User's Guide 2-16 BreezeNET BU-DS.11/RB-DS.11
2.7.2 Connecting the Indoor-to-Outdoor Cable
1. Remove the two screws holding the waterproof seal assembly to the Outdoor unit and remove
the waterproof seal.
2. Unscrew the top nut from the waterproof seal.
3. Route an uncrimped straight Ethernet cable (8-wire, 24 AWG pin-to-pin) through the top nut
and the waterproof seal. Refer to Appendix B for instructions on preparing the RJ-45 cable
connector.
Note: The 8-wire cable should be shielded.
1. Insert and crimp the RJ45 connector.
2. Connect the Ethernet cable to the Outdoor unit Ethernet connector.
3. Replace the waterproof seal assembly to the Outdoor unit and then replace the top nut.
Figure 2-5. Routing the Indoor-to-Outdoor Cable through the Waterproof Seal