User's Guide

Installation
BreezeNET BU-DS.11/RB-DS.11 2-1 User’s Guide
2. INSTALLATION
2.1 Quick Start to Wireless Networking
Perform the following steps to configure a WLAN for the first time:
1. Physically connect the BU-DS.11/RB-DS.11 units to the Ethernet LAN. Make sure they are
switched on. The DS.11 wireless network will be up and running immediately. If you are content
with the default settings of the BU-DS.11/RB-DS.11 units, you can stop right here. It is more
likely however, that you want to assign different radio frequencies to each BU-DS.11/RB-
DS.11, or impose some restrictions on the use of your wireless network.
2. To be able to manage the BU-DS.11/RB-DS.11 units via SNMP, each BU-DS.11/RB-DS.11
needs a unique IP address. If you provide a DHCP or BOOTP service on your LAN (and have
sufficient free IP addresses available) this will be taken care of automatically. If not, refer to
Section 3.1.1 for further information on assigning IP addresses.
3. Use the BreezeNET DS.11 Management utility, described in Chapter 3 of this manual, to
configure the network settings to reflect your configuration.
4. Select the radio channels of the BU-DS.11/RB-DS.11 units according to your cell plan.
See Section 3.1.5 for further information. Add descriptive information about each unit for later
reference.