User Manual

SA-PCR PRO.11 PC Card Installation, Setup, and Management
BreezeNET PRO.11 Series 4-15 User’s Guide
The WLAN Parameters tab contains the following parameters:
ESSID – An ASCII string of up to 32 characters used to identify a
WLAN that prevents the unintentional merging of two co-located
WLANs. It is essential that the ESSID is set to the same value in all
stations and Access Points in the extended WLAN.
Note: The ESSID is case-sensitive.
Maximum Data Rate – By default, the unit adaptively selects the
highest possible rate for transmission. Under certain conditions (for
range/speed trade-off) you may decide not to use the higher rates.
Possible values are 1, 2, or 3 Mbps.
Transmit Diversity – By default, the unit dynamically selects the
antenna where reception and transmission is optimal. If your model has
an external antenna and uses only a single antenna, set Transmit
Diversity to transmit only from that single antenna. Antenna number one
is the antenna nearest the yellow LED.
Load Sharing – When installing a Wireless LAN network in a high-
traffic environment, you can increase the aggregate throughput by
installing multiple APs to create co-located cells. Enable Load Sharing
to cause your stations to equally divide their traffic between the available
APs.
Note: Parameter changes take effect only after reset (refer to section 4.2.3,
Resetting the PC Card).