User Manual

SA-PCR PRO.11 PC Card Installation, Setup, and Management
BreezeNET PRO.11 Series 4-2 User’s Guide
4.1.2. Before You Begin
Before installing, do the following:
• Verify that the AP unit with which the SA-PCR unit will work is an
AP-10 PRO.11. The SA-PCR PRO.11 will work only with an AP-10
PRO.11 unit.
• It is advisable to turn on the AP before installing the SA-PCR, thereby
enabling you to use the SA-PCR LEDs to check the status of the SA-
PCR when installation is complete. See section 4.1.4 for explanation of
the LEDs.
• Uninstall any previous versions of the drivers or applications (refer to
section 4.1.8). You can check the version of the current installation by
viewing the Maintenance tab of the Configuration application.
• When installing on Windows 95/98, verify that you have the Windows
CD with you, or that the Windows CAB files are installed on your local
hard disk in a directory whose name does not exceed 8 letters. When the
CAB files are on the disk, they are usually found in
C:\Windows\Options\Cabs.
• When installing on Windows NT, verify that you have the Windows NT
CD with you, or that the Windows NT distribution files are installed on
your local hard disk. During installation, enter the path of the
distribution files whenever a message appears asking for them.
4.1.3. Installing SA-PCR Drivers
The procedure for installing the SA-PCR drivers depends on your operating
system:
• For Windows 95, refer to section 4.1.3.1.
• For Windows 98, refer to section 4.1.3.2.
• For Windows NT, refer to section 4.1.3.3.