User Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-12 User’s Guide
Partial – All parameters revert except for Japan Call Sign (if
applicable), IP Address, Subnet Mask, Default Gateway, Hopping
Sequence, Hopping Set, ESSID, Transmit Diversity, Long Range,
Preferred AP, IP Filtering, Hopping Standard, Power Level, Auto
Calibration.
3.5. Advanced Settings Menu
BreezeNET PRO.11 Series (SA-10)
Version: 4.211
Date: 25 Jun 1998 15:46:24
Advanced menu
================
1 - Compatibility
2 - Roaming
3 - Performance
4 - Radio
5 - Rate
6 - AP Redundancy Support
7 - Maintenance
Select option >
Figure 3.3: Advanced Settings Menu
Modification of most of the parameters that can be accessed from this menu
is limited to Certified BreezeCOM Engineers only. The Installer has access
to modify the following parameter of the Performance menu:
Dwell Time (AP Only) – The time spent on a radio channel before
hopping to the next channel in the sequence.
The Installer also has access to modify the following parameter of the
Radio menu:
Auto Calibration – When the unit is started, it performs an internal self-
test. Part of this test is automatic calibration of the DC Offset and
deviation pattern. Auto Calibration is not supported in the “DE” models,
and it therefore must be disabled for “DE” units.
The following sections describe the important parameters and relevant
information in the Advanced Settings menu that can be viewed, but not
modified, the the Installer.