User Manual
Device Setup and Management
BreezeNET PRO.11 Series 3-11 User’s Guide
will switch back to Reject Unknown bridging mode. This procedure
prevents packets destined for stations behind the bridge from getting
lost. The value of this parameter is the length of time in seconds that the
AP will remain in special mode.
• IP Filtering – Whether IP filtering is enabled for the unit. Enable IP
Filtering to filter out any other protocol (such as IPX) if you want that
only IP traffic will pass through the WLAN.
• Tunneling – Whether the unit performs tunneling. Enable Appletalk
tunneling if the network contains a mix of Ethertalk1 (ET1) and
Ethertalk2 (ET2) stations to ensure smooth communications. Enable IPX
tunneling if IPX protocol is running over your network. Be sure to set all
units to the same tunneling setting.
• Broadcast Relaying (AP Only) – Whether the unit performs broadcast
relaying. When Broadcast Relaying is enabled, Broadcast packets
originating in WLAN devices are transmitted by the AP back to the
WLAN devices, as well as to the LAN. If it is disabled, these packets are
sent only to the local wired LAN and are not sent back to the WLAN.
Disable Broadcast Relaying only if you know that all Broadcast
messages from the WLAN will be destined to the wired LAN.
• Unicast Relaying – Whether the unit performs Unicast relaying. When
Unicast Relaying is enabled, Unicast packets originating in WLAN
devices can be transmitted back to the WLAN devices. If this parameter
is disabled, these packets are not sent to the WLAN even if they are
intended for devices on the WLAN. Disable Unicast Relaying only if
you know that all Unicast messages from the WLAN will be destined to
the local wired LAN.
3.4.5. Station Control
The Station Control Menu contains the following options:
• Reset Unit – Resets the BreezeNET PRO.11 unit and applies any
changes made to the system parameters.
• Set Factory Defaults –When this option is implemented, system
parameters revert back to the original factory default settings. There are
two options:
• Full – All parameters revert to defaults except for Japan Call Sign (if
applicable).