User Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-5 User’s Guide
relevant only to the SA-10). The AP does not forward packets to the
station when it is in this mode.
Associated - The station is associated with an AP and has adopted
the attached PC MAC address (for SA-10) or uses the unit’s H/W
address (SA-40 and WB-10), and is receiving packets from the LAN.
AP Address (Station Only) – Address of the AP with which the unit is
currently associated.
Current Number of Associations (AP Only) – Total number of stations
currently associated with this AP.
Number of Associations Since Last Reset – For stations, this indicates
the total number of associations and disassociations with various APs.
This is usually an indication of roaming. When the unit is an AP, this
field indicates how many station are currently associated with this
particular AP.
Current Number of Authentications (AP Only) – Total number of
stations currently authenticated with this AP. A station may be
concurrently authenticated with several APs, but is associated with only
one AP at a time.
Maximum Number of Authentications (AP Only) Maximum number
of stations that were authenticated with this AP at one time.
3.4.2. IP and SNMP Parameters
All BreezeNET PRO.11 units contain IP Host software. This software is
used for testing the unit for SNMP management functions and for
downloading software upgrades using the TFTP protocol.
IP Address – IP address of the unit.
Subnet Mask – Subnet mask of the unit.
Default Gateway Address – Gateway address of the unit.
SNMP Traps – Whether this unit sends SNMP traps. If enabled, when
an event occurs, a trap is sent to the defined host address (see section
9.1.2 for a list of traps). You can configure the host address to which the
traps are sent through SNMP management.