User Manual

Device Setup and Management
BreezeNET PRO.11 Series 3-2 User’s Guide
⇒⇒ To use Local Terminal Management:
1. Press an option number to open/activate the option. You may need
to press Enter in some cases.
2. Press Esc to exit a menu or option.
3. Reset the unit after making configuration changes.
3.2. Configuration Screens
Listed below are the menus, sub-menus, and parameters/options in the
terminal program that the Installer can edit. Default values are listed where
applicable.
Numbers in the table below indicate how to reach each option. For example,
to reach the 1.2.1 IP Address option, start at the main menu and press 1,
then 2, and then 1.
Menu Sub-Menu Parameter/Option Default Values
1. System
Config-
uration
1.1 Station
Status
• Unit Mode
• Unit H/W Address
• Unit WLAN Addr (SA-10/40, WB-10 Only)
• Station Status (SA-10 Only)
• AP Address (SA-10/40 Only)
• Current Number of Associations (AP Only)
• Number of Associations Since Last Reset
• Cur. Number of Authentications (AP Only)
• Max Number Authentications (AP Only)
1.2 IP and
SNMP
Parameters
1.2.1 IP Address
1.2.2 Subnet Mask
1.2.3 Default Gateway Address
1.2.4 SNMP Traps
1.2.5 Display Current Values
Enabled
1.3 Wireless
LAN
(WLAN)
Parameters
1.3.1 Hopping Sequence (AP Only)
1.3.2 Hopping Set (AP Only)
1.3.3 ESSID
1.3.4 Maximum Data Rate
1.3.5 Transmit Diversity
1.3.6 Mobility
1.3.7 Load Sharing
1.3.8 Long Range
1.3.9 Preferred AP (SA-10/40, WB-10 Only)
1.3.A Display Current Values
1 (FCC standard)
2 (FCC standard)
ESSID1
3Mbps
Use 2 Antennas*
Stationary
Disabled**
Disabled
Not Set
1.4 Bridging 1.4.1 LAN-WLAN Bridge Mode (AP Only)
1.4.2 Intelligent Bridging Period (AP Only)
1.4.3 IP Filtering
1.4.4 Tunneling
1.4.5 Broadcast Relaying
1.4.6 Unicast Relaying
Reject Unknown
15 sec
Disabled
Both
Enabled
Enabled