User Manual

Introduction To The BreezeNET PRO.11 Series
BreezeNET PRO.11 Series 1-10 User’s Guide
Transmission and reception can be continued while moving at high speed
with no data packet loss or duplication.
The PC Card is available in two models:
• SA-PCR PRO.11 with two integrated omni-directional retractable
antennas.
• SA-PCD PRO.11 with two external antenna connector ports.
1.3.6. Extended Range Access Point and Bridge
Note: This product complies with European ETSI 300-328 and should only be used
in countries which implement this standard.
The BreezeNET WB-10DE is a high-speed, wide-range wireless LAN
bridge that provides connectivity to remote Ethernet networks.
The WB-10DE communicates with the BreezeNET AP-10DE Access Points
of the remote LANs effectively creating an extended wireless network
spanning sites situated up to 5 Km apart. In this way a central Ethernet LAN
may be connected with one or more branch office LANs.
The WB-10DE and AP-10DE products comply with European ETSI
standard 300-328. They should not be used in countries where FCC
standards are applicable.
The WB-10DE and AP-10DE can be used as a point-to-point as well as a
point-to-multipoint solution.
Note: The WB-10DE and AP-10DE are not compatible with the BreezeNET
PRO.11 Series. The SA-10 PRO.11, SA-PCR PRO.11, SA-40 PRO.11, AP-10
PRO.11 and WB-10 PRO.11 units cannot communicate with the AP-10DE
or the WB-10DE.
The BreezeNET AP-10DE and WB-10 DE contain an embedded SNMP
agent and software downloading capabilities enabling effective
management. Software upgrades are downloaded using TFTP protocol via
the Ethernet ports or via the wireless LAN and Access Point.
The BreezeNET DE Access Point and Bridge are available for use with
external antenna connector ports as seen in Figure 1.4.