User Manual

Accessory Installation
BreezeNET PRO.11 Series 6-5 User’s Guide
6.3. RFS 122 Radio Frequency Splitter
The RFS 122 Radio Frequency Splitter is used to split the RF signal
generated by a transmitter into two signals. These signals are then sent to
two different and independent antennas. The RFS 122 enables radio
transmission using two directional antennas connected to the same port of
the BreezeNET PRO.11 unit. Similarly, the splitter is used to combine two
receiving antennas to one antenna connector.
Before installing the RFS 122, configure the BreezeNET PRO.11 unit via the
Monitor to transmit through Antenna 2 only using the Transmit Diversity
parameter (see section 3.4.3), and connect the RFS 122 to antenna
connector 2.
For technical specifications, refer to section 9.2.4, Specifications for RFS
122 Radio Frequency Splitter.
6.3.1. Installing the RFS 122
The following diagram illustrates RFS-122 installation.
Figure 6.3: RFS-122 Connection Diagram
6.4. AL 1 Lightning Arrestor
The AL 1 Lightning Arrestor is used to protect transmitters and receivers
from transients originating from lightning or EMP.
The AL 1 is gas tube-based and is not radioactive. The gas discharge tube
can sustain several transients if the time period between transients is
sufficient to allow the tube to cool down.