User Manual

Accessory Installation
BreezeNET PRO.11 Series 6-2 User’s Guide
6.1.1. Installing the TPA 24
⇒⇒ To install the TPA 24:
1. Choose one of the TPA 24 models according to the power level at
the input of the booster. In general the NH model is used. For
installations with long cables (high attenuations), the NL model
should be used.
2. Choose one of the antenna connectors to be used for transmission.
This connector is called the transmit antenna of the unit.
3. Configure the BreezeNET PRO.11 unit via the Monitor to transmit
through the transmit antenna using the Transmit Diversity
parameter (see section 3.4.3).
Figure 6.1: TPA 24 Installation
4. Connect the TPA 24 RF output directly to the transmit antenna.
5. Attach the TPA 24 RF input to the Power Inserter with the RF
cable. The Power Inserter must be installed indoors.