User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
41
A.5.1. Saving a Configuration
You can save your current configuration in the following way:
1. Press File from top menu
2. Choose Save Configuration
3. Enter at the bottom the Configuration Name and Comment
4. Press the Save button
Figure 19: Save Configuration
A.5.2. Loading a Configuration
You can load past configurations from the database in the following way:
1. Press File from top menu
2. Choose Load Configuration
3. Click on the chosen configuration
4. Press the Load button
A.5.3. Deleting a Configuration
You can delete a configuration from the database in the following way:
1. Press File from top menu
2. Choose Delete Configuration
3. Click on the chosen configuration
4. Press the Delete button