User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
30
Note: GPS changes will take place only after resetting the remote unit (see section 3.4 controlling
remote units)
13.4.4 Deleting a Remote Unit from the Database
1. From the remote unit Maintenance menu choose Edit/Add remote unit
2. Choose the relevant remote unit from the list
3. Press the EDIT button on the left side of the row
4. An information screen will appear on the right side
5. Press the DELETE button
6. Press the CONFIRMATION button to delete
Note: Always leave at least one remote unit in the database. The database shouldn’t be empty
13.5 GPS Maintenance
13.5.1 Editing a GPS
1. From the GPS Maintenance menu choose View Global Parameters
2. Choose the relevant GPS from the list
3. Press the EDIT button on the left side of the row
4. An information screen will appear on the right side
5. Modify the required parameters: