User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
28
13.4 Controlling Remote Units
13.4.1 Controlling a Single Remote Unit
1. From the INFO page press SEND CONTROL
2. Alternatively, from the remote unit Maintenance menu choose remote unit Commands
3. Search for the relevant remote unit according to the remote unit ID/Location/Information
4. The chosen remote unit will be displayed with configuration information
5. Press the CONTROL button on the left side of the row. A window will open.
6. Choose the required Command
OUTPUT - remote unit RF Output Enable – On/Off
Counters – Reset all unlock counters (Pilot/Synthesizers/monitor)
Remote unit Reset – Reset the remote unit software
Instance 1 – Turn instance 1 output RF off
Instance 2 Reset – Turn instance 2 output RF off
7. Press the SEND button
Note: Only a single command can be issued!
13.4.2 Issuing a Global Command
A global command affects all the remote units in the network.
1. From the remote unit Maintenance menu choose Global Commands
2. Choose the required Command
Remote unit RF Output Enable – On/Off
Counters Reset– Reset all unlock counters (Pilot/Synthesizers)
Remote unit Reset – Reset the remote unit software
Instance 1– Turn instance 1 output RF off