User's Manual
Table Of Contents
- 1 Introduction
- 2 The Concept
- 3 BreezeCELL Architecture
- 4 BreezeCELL Network Elements
- 5 Frequency Allocations
- 6 MIMO Support
- 7 Monitoring & Control
- 8 Installation Requirements and Procedures
- 9 Headend Equipment Installation
- 9.1 Connector Information
- 9.2 Rack Installation
- 9.3 Connecting the BreezeCELL Equipment
- 9.4 Connecting the Monitoring System
- 9.5 Connecting External Alarms
- 9.6 Connecting the Base Stations
- 9.7 UDC Configuration
- 9.8 Pilot Master/Slave Configuration
- 9.9 Measurements
- 9.10 Connecting to the Coax TV Networks
- 9.11 Measurements
- 9.12 Localized Testing Port
- 9.13 Determining BTS Output Power VS. Remote Unit Output Power
- 10 Coax Network Amplifier Installation (if applicable)
- 11 Remote Unit Installation
- 12 Preparing for Remote Unit Installation
- 13 Normal Operations
- 14 Acceptance Testing
In-building Cellular Solution for Commercial Buildings UDC Software Configuration Tool
BreezeCELL
18
Coaxial Cable (F-Type Connectors)
Power Supply (provided separately), complying with the following specifications:
Certified to the EU market:
According to EN/IEC 60950-1 (LPS evaluated)
Rated Input: 100-240VAC, 0.5-0.17 A, 50 or 60 Hz
Rated Output: 5.7 ± 0.5 VDC, 2.7 A
11.4 Installation and Testing Procedure
Figure 15: Remote Unit Rear View
1. Turn off the TV and the TV Set Top Box (if exists)
2. Identify the Coaxial Cable that is connected between the Cable TV Outlet and the TV or the Set
Top Box. Disconnect this cable from the TV or Set Top Box and connect it to the RF IN connector of
the remote unit.
3. Connect the TV connector of the remote unit to the TV or the Set Top Box with a Coaxial cable
(included in the Installation Kit). Turn on the TV (and the TV Set Top Box).
4. Connect the Power Supply (included in the Installation Kit) to the DC Input of the remote unit.
Secure the DC cable using the DC cable holder. Connect the Power Supply to the electrical socket.
5. Verify that the LED on the remote unit’s front illuminate. The LED should turn orange and after a
few seconds turn green.
6. Verify that the reception of TV programs is in order.
CAUTION
Use only the power supply provided with the installation kit