User's Manual Part 2

BreezeCOMPACT System Manual
Chapter 2 - BreezeCOMPACT InstallationConnecting the BreezeCOMPACT Cables
Chapter 2 - BreezeCOMPACT Installation Connecting the BreezeCOMPACT Cables
52
2.7 Connecting the BreezeCOMPACT Cables
2.7.1 Introduction
This chapter describes how to prepare and connect all the required cables to the BTS. A DC and a DATA
cable are required to connect the BTS to the backhaul.
The BreezeCOMPACT is provided with sealing glands on all the cable connectors. The cables are to be
connected to the BTS by inserting the cable connector through the sealing gland. Some of the cables
provided by Alvarion are supplied crimped and with a sealing gland already attached to them.
For connecting cables to connectors with sealing glands, refer to “Using the Connector Sealing
Accessories” on page 61.
To ensure proper sealing of the glands use only the special wrench supplied with the BTS (see
Figure 2-21).
Figure 2-21: BreezeCOMPACT with Sealing Gland Wrench
Sealing gland
wrench
LEDs
Sealing gland