User's Manual Part 2

BreezeCOMPACT System Manual
Chapter 4 - Operation and AdministrationBS Menu
Chapter 4 - Operation and Administration BS Menu
119
4.7.2.6.3.3.9 802.1p Priority Marking
The 802.1p priority to be used for marking traffic. The range is 0-7.
A change in 802.1p Priority Marking will take effect after next reset.
4.7.2.6.4 ASN-GW Load Balancing
At the BTS level, up to two pools (with different priorities), each with up to 10 ASN-GWs, can be defined
(see “ASN-GW Load Balancing Pools” on page 89). The BS will “inherit” these pools. It should be noted
the ASN-GW defined in the BS as the Default Authenticator will be automatically added to the Primary
Pool that is the higher priority pool (although it will not be shown as belonging to the pool).
At the BS level, you can enable/disable the use of each of the two pools. The Secondary Pool can be
enabled only if the Primary Pool is enabled and includes at least one entry. Note that if both pools are
disabled, or if the enabled pool(s) are empty, the ASN-GW load balancing feature is disabled and only
the Default Authenticator will be used.
The ASN-GW Load Balancing menu includes the following options:
 Pools Availability
 NWG Compliant
 Primary Pool
 Secondary Pool
4.7.2.6.4.1 Pools Availability
The Pools Availability option enables viewing/updating the status (Enabled/Disabled) of each of the
pools. The Secondary Pool can be enabled only if the Primary Pool is enabled.
A change in a Pool Availability will take effect after next reset.
4.7.2.6.4.2 NWG Compliant
Not supported in the current release.
4.7.2.6.4.3 Primary Pool
The Primary Pool option enables viewing the IP Address and current Connectivity Status for each of the
ASN-GWs in the pool, based on selection of the ASN-GW Index.
4.7.2.6.4.4 Secondary Pool
The Secondary Pool option enables viewing the IP Address and current Connectivity Status for each of
the ASN-GWs in the pool, based on selection of the ASN-GW Index.
4.7.2.7 Management Thresholds
The Management Thresholds menu includes the following option:
 Noise and Interference Level Thresholds
4.7.2.7.1 Noise and Interference Level Thresholds
The Noise and Interference Level Thresholds menu enables viewing/updating the value configured for
the following parameter: