User's Manual Part 2

BreezeCOMPACT System Manual
Chapter 4 - Operation and AdministrationBS Menu
Chapter 4 - Operation and Administration BS Menu
110
 FFR DL Map (ffrDlMap):
» First zone includes FCH and maps transmitted using reuse 3 (segmented PUSC).
» Second zone includes HARQ and Non-HARQ data traffic transmitted using reuse 1 (full load
PUSC). May include broadcasts and management messages.
FFR DL Map is supported only with a BS bandwidth of 10 MHz.
The default FFR Mode is None.
A change in FFR Mode will take effect after next reset.
4.7.2.2.2 General
The Air Frame Structure - General Tmenu enables viewing/updating the values configured for the
following parameters:
 Cell ID
 Preamble Group
 Segment Number
 Preamble Index
 Total Uplink Duration
 Operational Status Channel 1
 Operational Status Channel 2
 Operational Status Channel 3
 Operational Status Channel 4
4.7.2.2.2.1 Cell ID
The Cell ID (IDCell) used for preamble selection. The range is from 0 to 31.
A change in Cell ID will take effect after next reset.
4.7.2.2.2.2 Preamble Group
The preamble group (1 or 2). A value of 2 is applicable only for the following combinations of Segment
Number and Cell ID values:
Segment Number=0, Cell ID=0, 3, 6, 9, 12, 15.
Segment Number=1, Cell ID=1, 4, 7, 10, 13, 16.
Segment Number=2, Cell ID=2, 5, 8, 11, 14, 17
The default is 1.
A change in Preamble Group will take effect after next reset.
4.7.2.2.2.3 Segment Number
The segment (BS) number in a three sector BS (0-2).