User's Manual Part 2

BreezeCOMPACT System Manual
Chapter 4 - Operation and AdministrationBS Menu
Chapter 4 - Operation and Administration BS Menu
106
 ctcQamSixtyFourFiveOverSix 64-QAM 5/6
The default is ctcQpskOneOverTwo (QPSK 1/2).
A change in Basic Rate for Management will take effect after next reset.
4.7.2.2.1.2.2 Basic Rate for Data
The downlink basic rate for HARQ data traffic in reuse 1 region:
 ctcQpskOneOverTwoTimesSix (QPSK 1/2 Repetition 6)
 ctcQpskOneOverTwoTimesFour (QPSK 1/2 Repetition 4)
 ctcQpskOneOverTwoTimesTwo (QPSK 1/2 Repetition 2)
 ctcQpskOneOverTwo (QPSK 1/2)
 ctcQpskThreeOverFour (QPSK 3/4)
 ctcQamSixteenOneOverTwo 16-QAM 1/2
 ctcQamSixteenThreeOverFour (16-QAM 3/4)
 ctcQamSixtyFourOneOverTwo (64-QAM 1/2)
 ctcQamSixtyFourTwoOverThree (64-QAM 2/3)
 ctcQamSixtyFourThreeOverFour (64-QAM 3/4)
 ctcQamSixtyFourFiveOverSix 64-QAM 5/6
The default is ctcQpskOneOverTwo (QPSK 1/2).
A change in Basic Rate for Data will take effect after next reset.
4.7.2.2.1.2.3 DL Data Permutation Base
The permutation base used in the downlink data zone.
The valid range is from 0 to 31.
A change in DL Data Permutation Base will take effect after next reset.
4.7.2.2.1.3 First Zone
The First Zone menu enables viewing/updating the values configured for the following parameters:
 Basic Map Repetition
 Minimum Size
 Maximum Size
 Maximum Map Size
4.7.2.2.1.3.1 Basic Map Repetition
The basic repetition used in the transmission of the maps using QPSK 1/2. The available options are 1, 2,
4 and 6. (1 means no repetitions).
If FFR Mode is other than None, only values 1 and 2 should be used.