Manualshelf

User's Manual Part 2

ManualsBrandsAlvarion Technologies ManualsElectronicsBase station transceiver
12345678910
BreezeCOMPACT System Manual
Chapter 2 - BreezeCOMPACT InstallationGPS Installation
Chapter 2 - BreezeCOMPACT Installation GPS Installation
49
2.6.4 Connecting the GPS
The Outdoor GPS Receiver is connected to the BTS via a Cat. 5E Ethernet cable. Before connecting the
cable, make sure that the length of the cable is sufficient to reach the BTS.
The shielded Cat.5E Ethernet cable is supplied with a rubber bushing and a sealing gland nut. During
installation, you replace the sealing gland nut and rubber bushing that are on the GPS with the same
parts that are supplied with the cable.
Refer to Figure 2-17.
1 Measure the distance and make sure that the length of the cable is sufficient to reach the BTS.
2 Remove the sealing gland plug from the gland nut.
3 Open the sealing gland nut and remove it. Do not disassemble the gland base from the bracket.
4 Remove the rubber bushing from the sealing gland.
To connect the GPS cable:
INFORMATION
The removed parts (sealing gland plug, nut and rubber bushing) can be disposed of, as they are replaced
by the same parts supplied with the GPS cable.
Figure 2-17: GPS Components