User's Manual Part 2

BreezeCOMPACT System Manual
Chapter 4 - Operation and AdministrationBS Menu
Chapter 4 - Operation and Administration BS Menu
101
4.7.1.5 Cell ID
The Cell ID (IDCell) used for preamble selection. The range is from 0 to 31.
4.7.1.6 Segment Number
The segment (BS) number in a three sector BS (0-2).
4.7.1.7 Total Uplink Duration
The total duration of the uplink in a frame, in slots (one slot equals 3 symbols).
To avoid BS-BS interference, the Total Uplink Duration must be identical in all BSs in the same
geographical region.
The range is 4-7 for a BS bandwidth of 5 or 10MHz, 3-5 for a BS bandwidth of 7MHz.
4.7.1.8 Basic Map Repetition
The basic repetition used in the transmission of the maps using QPSK 1/2. The available options are 1, 2,
4 and 6. (1 means no repetitions).
If FFR Mode (see “FFR Mode” on page 109) is other than None, only values 1 and 2 should be used.
If BS BW=5MHz (not applicable for current release supporting only 10 MHz bandwidth) only values 1, 2,
and 4 should be used.
4.7.1.9 DL Data Permutation Base
The permutation base used in the downlink data zone.
The valid range is from 0 to 31.
4.7.1.10 UL Feedback Zone Permutation Base
The permutation base used in the uplink feedback zone.
The valid range is from 0 to 69.
4.7.1.11 UL Data Permutation Base
The permutation base used in the uplink data zone.
The valid range is from 0 to 69.
4.7.1.12 IP Address
The IP address of the bearer interface of the BS. Must be unique in the network.
4.7.1.13 Paging Group ID
The Paging Group ID of the BS.
The range is from 0 to 65535. 0 means that Idle Mode is not enabled. If Idle Mode is enabled (Paging
Group ID is not 0), should be unique in the Radio Access Network (different Paging Group ID for each