User's Manual Part 2

BreezeCOMPACT System Manual
Chapter 3 - CommissioningConfiguring Parameters Required for Management Connectivity
Chapter 3 - Commissioning Configuring Parameters Required for Management Connectivity
69
 External Management IP Address. Must be unique in the managed network. The default is
192.168.1.1. Note that in Unified Connectivity Mode the External Management IP Address should be
within the addresses range defined by BS Bearer IP Address and Bearer Subnet Mask.
 External Management Subnet Mask. The default is 255.255.255.0. In Unified Connectivity Mode
should be configured to the value of the Bearer Subnet Mask.
 External Management Next Hop Gateway. Must be within the range defined by External
Management IP Address and External Management Subnet Mask. The default is 0.0.0.0 (must be
changed to a valid value if IP address of external management equipment is not within the range
defined by External Management IP Address and External Management Subnet Mask). In Unified
Connectivity Mode should be configured to the value of the Bearer Next Hop Gateway.
 External Management VLAN ID. The default is 12. In Unified Connectivity Mode should be configured
to the value of the Bearer VLAN ID. Otherwise it must differ from the Bearer VLAN ID.
 Local Management IP Address and Local Management Subnet Mask. You may change the Local
Management IP Address (the default is 172.31.0.1) and Local Management Subnet Mask (the default
is 255.255.255.0). However, it is recommended to always maintain the default value to ensure
availability of known IP parameters for local connectivity.
3.2.4 Configuring the L1 and L2 Parameters (if necessary)
3.2.4.1 Selecting the Active Port
By default the Administrative State of DAT2 (Data Port 2) is up and that of DAT1 (Data Port 1) is down. If
an SFP is installed and DAT1 should be used for remote management (In Band or unified Connectivity
Mode):
 Select Data Port 2 (BTS>Connectivity>L1 & L2>Select>Port Number>2). Select the Update option.
 You will be prompted to configure the Administrative State and the Port Negotiation Mode, Port
Speed and Duplex Mode. Change the Administrative State to down.
 Select Data Port 1 (BTS>Connectivity>L1 & L2>Select>Port Number>1). Select the Update option.
 You will be prompted to configure the Administrative State and the Port Negotiation Mode, Port
Speed and Duplex Mode. Change the Administrative State to up. Typically other parameters should
not be changed (default Port Negotiation Mode is auto. If manual configuration of port parameters is
required, refer to Modifying the Ports Speed and Duplex Mode below).
3.2.4.2 Modifying the Ports Speed and Duplex Mode
The default Port Negotiation Mode of all ports is auto. Typically auto negotiation mode should be used.
However, if manual setting of physical interface parameters is required for any of the active ports:
 Select the applicable port (BTS>Connectivity>L1 & L2>Select>Port Number>1/2/3). Select the Update
option.
 Configure the Port Negotiation Mode parameter to manual.