User's Manual Part 2

BreezeCOMPACT System Manual
Chapter 3 - CommissioningIntroduction
Chapter 3 - Commissioning Introduction
67
3.1 Introduction
After completing the installation process some basic unit's parameters must be configured locally using
the Monitor program to enable discovery by the Element Management System and remote management
of the unit.
Refer to “The Monitor Program” on page 78 for information on how to access the Monitor program
using Telnet and how to use it.
It is assumed that the unit is a new one (was never configured after being shipped from factory).
Otherwise, it is recommended to reset the unit to its factory default values before proceeding with
following configuration steps: Enter the Monitor program and select BTS>Unit Control>ShutDown
Operation>Update>resettoFactoryDefault (you will be prompted to confirm the requested action).