User's Manual Part 1
Table Of Contents
- BreezeCOMPACT System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 The BreezeCOMPACT Solution
- 1.3 Element Management Systems
- 1.4 Specifications
- 1.4.1 Modem & Radio
- 1.4.2 Sensitivity (per channel)*
- 1.4.3 Data Communication (Ethernet Interfaces)
- 1.4.4 Configuration and Management
- 1.4.5 Standards Compliance, General
- 1.4.6 Environmental
- 1.4.7 Mechanical and Electrical
- 1.4.8 Antennas
- 1.4.8.1 Attached, 3.3-3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.2 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx), with EDT
- 1.4.8.3 3.3 -3.8 GHz, 2 Ports 65º Dual Slant (x)
- 1.4.8.4 3.3 -3.8 GHz, 2 Ports 90º Dual Slant (x)
- 1.4.8.5 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.6 3.3 -3.8 GHz, 4 Ports 90º Double Dual Slant (xx)
- 1.4.8.7 3.3 -3.8 GHz, 90º Vertical
- 1.4.9 BMAX-4M-GPS Receiver Specifications
- Chapter 2 - BreezeCOMPACT Installation
BreezeCOMPACT System Manual
Chapter 2 - BreezeCOMPACT InstallationPole Mounting with an Attached Antenna
Chapter 2 - BreezeCOMPACT Installation Pole Mounting with an Attached Antenna
40
2 Hang the BTS screws on the BTS carriage hanging hooks. Locate the carriage hooks between the
washers and the BTS.
3 Insert the four threaded rods through the holes in the carriage. If you intend to mount the GPS on the
carriage, thread the rods through the GPS bracket as well (Refer to “To install the GPS on the
carriage:” on page 47’ and Figure 2-9).
4 Attach nuts, washers and spring washers to both sides of the threaded rods and fasten to fix the rods
in place on the carriage (Figure 2-8).
Figure 2-7: Preparing the BTS for Installation
M8x20 nuts, washers
and spring washers
Carrying hook