User's Manual Part 1
Table Of Contents
- BreezeCOMPACT System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 The BreezeCOMPACT Solution
- 1.3 Element Management Systems
- 1.4 Specifications
- 1.4.1 Modem & Radio
- 1.4.2 Sensitivity (per channel)*
- 1.4.3 Data Communication (Ethernet Interfaces)
- 1.4.4 Configuration and Management
- 1.4.5 Standards Compliance, General
- 1.4.6 Environmental
- 1.4.7 Mechanical and Electrical
- 1.4.8 Antennas
- 1.4.8.1 Attached, 3.3-3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.2 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx), with EDT
- 1.4.8.3 3.3 -3.8 GHz, 2 Ports 65º Dual Slant (x)
- 1.4.8.4 3.3 -3.8 GHz, 2 Ports 90º Dual Slant (x)
- 1.4.8.5 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.6 3.3 -3.8 GHz, 4 Ports 90º Double Dual Slant (xx)
- 1.4.8.7 3.3 -3.8 GHz, 90º Vertical
- 1.4.9 BMAX-4M-GPS Receiver Specifications
- Chapter 2 - BreezeCOMPACT Installation
BreezeCOMPACT System Manual
Chapter 2 - BreezeCOMPACT InstallationPole Mounting without an Attached Antenna (Standalone)
Chapter 2 - BreezeCOMPACT Installation Pole Mounting without an Attached Antenna (Standalone)
36
Refer to Figure 2-4 and Figure 2-5.
1 Thread two metal bands through the designated grooves in two clamps.
2 Attach the clamps to the BTS and use the screws, washers and spring washers to fasten the clamps to
the BTS (Figure 2-4)
3 Close and fasten the bands.
To mount the BTS on a pole of up to 6”(using metal bands):
Figure 2-4: Attaching the Clamps
Clamps
Screws, Washers
and Spring Washers
Grooves for Metal Bands
Metal Bands on
Clamps