User's Manual Part 1
Table Of Contents
- BreezeCOMPACT System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 The BreezeCOMPACT Solution
- 1.3 Element Management Systems
- 1.4 Specifications
- 1.4.1 Modem & Radio
- 1.4.2 Sensitivity (per channel)*
- 1.4.3 Data Communication (Ethernet Interfaces)
- 1.4.4 Configuration and Management
- 1.4.5 Standards Compliance, General
- 1.4.6 Environmental
- 1.4.7 Mechanical and Electrical
- 1.4.8 Antennas
- 1.4.8.1 Attached, 3.3-3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.2 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx), with EDT
- 1.4.8.3 3.3 -3.8 GHz, 2 Ports 65º Dual Slant (x)
- 1.4.8.4 3.3 -3.8 GHz, 2 Ports 90º Dual Slant (x)
- 1.4.8.5 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.6 3.3 -3.8 GHz, 4 Ports 90º Double Dual Slant (xx)
- 1.4.8.7 3.3 -3.8 GHz, 90º Vertical
- 1.4.9 BMAX-4M-GPS Receiver Specifications
- Chapter 2 - BreezeCOMPACT Installation
BreezeCOMPACT System Manual
Chapter 2 - BreezeCOMPACT InstallationPole Mounting without an Attached Antenna (Standalone)
Chapter 2 - BreezeCOMPACT Installation Pole Mounting without an Attached Antenna (Standalone)
34
2.4 Pole Mounting without an Attached Antenna
(Standalone)
When not using the attached antenna, mount the BTS on the pole using the pole mount kit supplied
with the BTS. Attach the sun-guard cover to protect from extreme heat.
Thread the screws through the designated holes in the cover and attach to the BTS. Fasten firmly.
Refer to Figure 2-2 and Figure 2-3.
1 Thread the four rods through the nuts, washers, spring washers, and two clamps, and fasten the
clamps to the BTS mounting holes.
2 Attach the BTS with the mounted clamps to the pole.
To mount the sun-guard cover:
Figure 2-1: Mounting the Sun-guard Cover
To mount the BTS on a pole of up to 4” (using clamps):
Screws
Sun-guard
Holes