User's Manual Part 1
Table Of Contents
- BreezeCOMPACT System Manual
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 The BreezeCOMPACT Solution
- 1.3 Element Management Systems
- 1.4 Specifications
- 1.4.1 Modem & Radio
- 1.4.2 Sensitivity (per channel)*
- 1.4.3 Data Communication (Ethernet Interfaces)
- 1.4.4 Configuration and Management
- 1.4.5 Standards Compliance, General
- 1.4.6 Environmental
- 1.4.7 Mechanical and Electrical
- 1.4.8 Antennas
- 1.4.8.1 Attached, 3.3-3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.2 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx), with EDT
- 1.4.8.3 3.3 -3.8 GHz, 2 Ports 65º Dual Slant (x)
- 1.4.8.4 3.3 -3.8 GHz, 2 Ports 90º Dual Slant (x)
- 1.4.8.5 3.3 -3.8 GHz, 4 Ports 65º Double Dual Slant (xx)
- 1.4.8.6 3.3 -3.8 GHz, 4 Ports 90º Double Dual Slant (xx)
- 1.4.8.7 3.3 -3.8 GHz, 90º Vertical
- 1.4.9 BMAX-4M-GPS Receiver Specifications
- Chapter 2 - BreezeCOMPACT Installation
iii
Legal Rights
BreezeCOMPACT System Manual
FCC and Industry Canada Radiation Hazard Warning
To comply with Industry Canada exposure requirements, and FCC RF exposure requirements in Section
1.1307 and 2.1091 of FCC Rules, the antenna used for this transmitter must be fixed-mounted on
outdoor permanent structures with a separation distance of at least 205 cm from all persons.
Industry Canada Statement
Users can obtain Canadian information on RF exposure and compliance from the Canadian
Representative:
Nick Dewar
Nick.Dewar@alvarion.com
Canadian Radio Standards Specifications (RSS) Compliance Statement
This device has been designed to operate with the antennas listed in Section 1.4.8, and having a
maximum gain of 18 dBi. Antennas not included in this list or having a gain greater than 18 dBi are
strictly prohibited for use with this device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
that the Equivalent Isotropically Radiated Power (EIRP) is not more than that permitted for successful
communication.
R&TTE Compliance Statement
This equipment complies with the appropriate essential requirements of Article 3 of the R&TTE Directive
1999/5/EC.
Safety Considerations - General
For the following safety considerations, “Instrument” means the BreezeCOMPACT units' components
and their cables.
Grounding
BTS chassis is required to be bonded to protective grounding using the bonding stud or screw provided
with each unit.
Safety Considerations - DC Powered Equipment
CAUTION ATTENTION
Risk of electric shock and energy hazard. Risque de décharge électrique et d'electrocution.
Restricted Access Area: The DC powered
equipment should only be installed in a Restricted
Access Area.
Zone d’Accès Limité: L’alimentation en courant
continue doit être installée dans une zone a accès
limité
Installation Codes: The equipment must be
installed according to the latest edition of the
country national electrical codes. For North
America, equipment must be installed in
accordance with the US National Electrical Code
and the Canadian Electrical Code.
Normes d’installation: les équipements doivent
être installes d’après les dernières normes en
vigueur. Pour l’Amérique du nord les équipements
doivent être installés d’après les normes
électriques nationales US et les normes électriques
Canadiennes.