User's Manual

Industry Canada statement:
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable
aux appareils radio exempts de licence. Son fonctionnement est sujet aux
deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris
un brouillage susceptible de provoquer un fonctionnement indésirable.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 165cm between the radiator & your body.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements IC
établies pour un environnement non contrôlé. Cet équipement doit être installé
et utilisé avec un minimum de 165cm de distance entre la source de
rayonnement et votre corps.
This device is intended only for OEM integrators under the following conditions:
(For module device use)
1) Due to the facts that this module has high built-in output power and with a high
gain direction antenna, the module can be used in a professional installed end
product only. The final product must be professional installed to make sure that
165 cm can be maintained between the antenna and users, and
2) The professional installer shall make sure that the all antennas are fully exposure
to the outside radar signal(s) source with no obstruction in between them for
proper DFS operation. Also, if extra length of cable is needed for the antenna
installation then a proper amplifier must be added to the path for compensating the
cable loss. Otherwise the DFS detection sensitivity will be impaired. The improper
installation of the antenna may reduce the antenna sensitivity and invalided the
certification.
3) The transmitter module may not be co-located with any other transmitter or
antenna.