User's Manual

Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 165cm between the radiator & your body.
This device is intended only for OEM integrators under the following
conditions:
1) Due to the facts that this module has high built-in output power and with a high
gain direction antenna, the module can be used in a professional installed end
product only. The final product must be professional installed to make sure that
165 cm can be maintained between the antenna and users, and
2) The professional installer shall make sure that the all antennas are fully exposure
to the outside radar signal(s) source with no obstruction in between them for
proper DFS operation. Also, if extra length of cable is needed for the antenna
installation then a proper amplifier must be added to the path for compensating the
cable loss. Otherwise the DFS detection sensitivity will be impaired. The improper
installation of the antenna may reduce the antenna sensitivity and invalided the
certification.
3) The transmitter module may not be co-located with any other transmitter or
antenna.
As long as 3 conditions above are met, further transmitter test will not be
required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this
module installed
IMPORTANT NOTE: In the event that these conditions can not be met (for
example certain laptop configurations or co-location with another transmitter),
then the FCC authorization is no longer considered valid and the FCC ID can
not be used on the final product. In these circumstances, the OEM integrator
will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna
may be installed such that 165cm may be maintained between the antenna and
users. The final end product must be labeled in a visible area with the following:
“Contains FCC ID:
LKT-BULTRA-5”. The grantee's FCC ID can be used only