User's Manual
Table Of Contents
- BreezeNET B130/B300 GigE Technical User Manual
- Chapter 1 - Getting Started
- Chapter 2 - Hardware Description
- 2.1 Power supply units (IDU)
- 2.2 Outdoor Units (ODU)
- 2.3 Installation Preparations
- 2.3.1 Required Components and Accessories
- 2.3.2 Antenna Placement
- 2.3.3 Antenna Poles Usage
- 2.3.4 Poles with Stretching
- 2.3.5 Wall Mounted Pole
- 2.3.6 Antenna Poles Requirements
- 2.3.7 Grounding when Using IDU-BS-G
- 2.3.8 Antenna Alignment
- 2.3.9 Precaution Measures
- 2.3.10 Service Cable Soldering Procedure
- 2.3.11 Tools Required at the Installation Site
- 2.4 BU/RB-B130D/B300D-5X-GigE
- 2.5 BU/RB-B130/B300-5X-GigE
- 2.6 Mounting Kit (MOUNT-KIT-85)
- 2.7 Specifications
- Chapter 3 - Basic Configuration Instructions
- Chapter 4 - Link Configuration
- Chapter 5 - Configuration Via Web Interface
- Chapter 6 - Supplementary Information
Chapter 5 - Configuration Via Web Interface Basic Settings
Alvarion BreezeNET B130/B300 GigE 70 Technical User Manual
5.3 Basic Settings
On the "Basic Settings" page the device configuration is performed. All the
parameters that are available for configuration are divided into the dedicated
sections (e.g. "General settings", "Radio Settings").
To show/hide the parameters of the section just click the section's header.
The listing and description of all the sections can be found below in this chapter.
To view the commands that will be executed on the device after pressing the
"Done" button, please use "Preview Configuration" button.
To apply the configuration changes to the unit use "Done" button.
Figure 5-1: Basic Settings
NOTE
After pressing "Done" button unit's current configuration will be updated according to the
parameters set on the "Basic Settings" tab. Unit will be turned into the switch mode.