Technical Manual

Chapter 4 - Link Configuration Link Diagnostic Tools
Alvarion BreezeNET B300 58 Technical User Manual
got a permanent source of interference. Otherwise, it means that a strong
interference source appears from time to time breaking your signal
 Concerning the fact that statistics module outputs the information for each
MAC-address separately, you can reveal the problem for some specific unit on
the wireless network
The "muffer stat" command shows the statistics only from registered devices.
To view statistics type the following command:
To reset all counters please type
4.1.2.4 Other Modes of Muffer
The muffer also has the following modes:
 mac mode. Compared to the mac2 mode this mode does not take link-level
ACK messages sent by protocol support devices into account
 mac2 mode. This mode is used to detect impulse interference and doesn't
disturb radio model normal operation.
 mac3 mode. Compared to mac2 mode this mode also performs calculation of
impulse interference.
 mynet mode. This mode performs the radio testing without disturbing radio
module's normal operation, but taking into account only packets from within
the given network
 sid mode. The sid regime allows estimating the number of currently operating
subscriber groups having different identifiers (SID), and the efficiency of air
links utilization. The analysis is carried out for all network identifiers at the
frequency previously specified for the radio module by rfconfig command.
 Sensor mode. In this mode shows the radio environment testing results on the
screen in a visual-digital format.
muffer stat
muffer stat clear