User's Manual
Table Of Contents
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - Products Description
- 1.1 BreezeMAX CPEs
- 1.2 Introducing BreezeMAX PRO-S CPE
- 1.3 Introducing BreezeMAX Si CPE
- 1.4 Voice and Networking Gateways
- 1.5 PRO-S CPE Specifications
- 1.6 Si CPE Specifications
- Chapter 2 - Installation
- 2.1 Installing the ODU of the PRO-S CPE
- 2.2 Installing the IDU-1D Indoor Unit of the PRO-S CPE
- 2.3 Installing the Si CPE
- 2.4 Installing the 3.5 GHz Detached Antenna
- 2.5 Installing the 2.3/2.5 GHz Detached Antenna
- Chapter 3 - Commissioning
- Chapter 4 - Operation
- 4.1 The SU Installer Monitor Program
- 4.2 Using the Monitor Program
- 4.3 The Main Menu
- 4.4 Unit Control Menu
- 4.5 Registration Parameters Menu
- 4.6 BST/AU ID Parameters Menu
- 4.7 ˘Radio Parameters Menu
- 4.8 Multirate and ATPC Parameters Menu
- 4.9 Performance Monitoring Menu
- 4.10 FDD Parameters (3.x GHz units only)
- 4.11 ˘SU Parameters Summary
- Appendix A - The Web Configuration Server
- Appendix B - Troubleshooting
- Glossary
82 Operation
Chapter 4 - Operation
Si2-L use second generation (IEEE 802.16e-ready) WiMAX chip. The “L”
suffix indicates that the SU was supplied with limited capabilities (limited
bandwidth).
Serial Number
MAC Address
MAC Address Control Number (a number computed from the MAC Address
that can be used for verification purposes)
Radio Band
HW Version: The version of the digital module
HW Configuration
RF Version: The version of the radio module
SU Interface Type (Si CPE): Ethernet or USB
Smart Card Status (Si CPE): Installed/Not Installed/Fault
Ethernet Port Operation Mode parameters and status (applicable only for
E-model units)
Ethernet Port Auto Negotiation Enable/Disable
Ethernet Port Speed and Duplex
Operation Mode: Advanced Si or Standard (not applicable in current version
supporting only Advanced Si mode). Standard is the air protocol of the first
generation BreezeMAX systems. Advanced Si is the air protocol used in the
WiMAX-ready systems, providing full support for Self Install SUs. In the
current release only Advanced-Si mode is applicable.
Unit Status: the connectivity status of the unit. Possible statuses are:
Searching for Base Station
NOTE
The displayed MAC address is the unit’s MAC address, used for management and communication.
The Si CPE U model (USB) has an additional MAC addresses for the USB controller. Since the USB
controller of the PC connected to the unit doesn't have an internal MAC address, the MAC address of
the USB controller is used as the MAC Address of the PC. When managing the unit via the USB port
(using any of the optional management tools), this MAC address can be viewed in the ARP table of
the PC.