User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 191 System Manual
4.3.6.2.4 Disabling and Deleting Rate Limiting Configuration for an Application
To disable and delete rate limiting configuration for an application, run the
following command:
[srcport
<port_num>]
Indicates the L4 source port
of the user-defined
application. specify the value
of this parameter exactly as
this field appears in the
TCP/UDP header.
Optional N/A 1-65535
[dstport
<port_num>]
Indicates the L4 destination
port of the user-defined
application. This parameter
should be specified exactly as
it appears in the TCP/UDP
header.
Optional N/A 1-65535
[protocol
<protocol_num>
]
Indicates the L3 protocol field
of the user-defined
application. This parameter
should be specified exactly as
it appears in the IP header
Optional N/A 0-255
[srcaddr
<ip_addr>]
Indicates the source IP
address of the user-defined
application.
Optional N/A Valid unicast IP
address
[dstaddr
<ip_addr>]
Indicates the pre-configured
destination IP address for the
NPU for which rate limiting for
this user-defined application
is to be configured. Specify
the IP address that is
assigned to the
external-management,
internal-management,
local-management or bearer
interface.
Optional N/A Valid unicast IP
address
[ethertype
<protocol_num>
]
Indicates the Ethernet type
field of the user-defined L2
protocol.
Optional N/A 1536-65535
[rate-Kbps] Indicates the rate, in Kbps, at
which an application can
send packets to the NPU.
Mandatory 100 1-1000000
Command
Modes
Rate limiting configuration mode