User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 186 System Manual
4.3.6.2.1 Enabling the Rate Limiting Configuration Mode
To enable the rate limiting configuration mode, run the following command:
npu(config)# rate-limit config
After you run this command, you can:
 Modify default rate limiting configuration parameters for pre-defined
applications (refer to Section 4.3.6.2.2)
 Configure rate limiting for user-defined applications (refer to Section 4.3.6.2.3)
 Disable rate limiting for specific applications (refer to Section 4.3.6.2.4)
4.3.6.2.2 Modifying Configuration Parameters for Pre-defined Applications
Rate limiting is configured and enabled for the following pre-defined applications:
 FTP
 Telnet
 TFTP
 SSH
 ICMP
 SNMP
NOTE
In addition, you can also display the number of non-conforming packets dropped by the rate limiting
feature. For details, refer to Section 4.10.1.3.
Command
Syntax
npu(config)# rate-limit config
Privilege
Level
10
Command
Modes
Global configuration mode