User Manual

Chapter 3 - Commissioning Completing the Site Configuration Using AlvariSTAR
4Motion 104 System Manual
3.2.2 Site Configuration
3.2.2.1 General Tab
ASN Topology - the default is Distributed ASNGW.
If you change it to Centralized ASNGW click Apply for the device to accept the
change.
3.2.3 Connectivity Configuration (optional)
3.2.3.1 IP Interface Screen
Configure the IP address of the Bearer interface:
1 Change the Administrative State to Down.
2 Click Apply.
3 Change the IP and/or any other parameter value, except VLAN ID.
4 Click Apply.
5 Change the Administrative State to Up.
6 Click on Apply to accept the changes.
3.2.3.2 IP Routing Screen
The IP Routing screen is used to define the static routes for traffic originating from
the NPU.
The static route for management traffic was already configured (see “Static Route
Definition” on page 101).
If necessary (depending on your specific backhaul network) you may configure
additional static route(s) for Bearer Traffic and/or Control Traffic. If additional
static routes were defined (or if you made any changes in the already configured
static route), click on the Apply button.
3.2.4 Equipment Configuration
3.2.4.1 AU
AU entities must be created for all installed AUs (you may create an AU entity also
for AUs that are not installed yet).
To create a new AU entity: