User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 162 System Manual
4.3.2.3.4 Removing an IP Address from an Interface
To remove an IP address from an interface, run the following command. Shut
down this interface before executing this command:
npu(config-if)# no ip address
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ip-address> Indicates the IP address to be
assigned to this IP interface.
The defaults are:
External Management:
192.168.1.1
Beare: 172.16.0.1
Local Management:
172.31.0.1
Mandatory Depends
on
interface
type.
Valid IP
address
<subnet-mask> Indicates the subnet mask to
be assigned to this IP
interface.
Mandatory 255.255.
255.0
Valid subnet
mask
Command
Modes
Interface configuration mode
IMPORTANT
An error may occur if you run this command when this IP interface is enabled. Shut down the IP
interface before executing this command
Command
Syntax
npu(config-if)# no ip address
Privilege
Level
10
Command
Modes
Interface configuration mode