User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 160 System Manual
 Assign an IP address to an interface (refer Section 4.3.2.3.3).
 Remove an IP address associated with an interface (refer Section 4.3.2.3.4).
 Modify the VLAN ID (refer Section 4.3.2.3.5).
 Modify the MTU (refer to Section 4.3.2.3.6).
4.3.2.3.2 Shutting down/Enabling an IP Interface
To modify configuration for an IP interface, first shut down the IP interface, using
the following command:
npu(config-if)# shutdown
After you have modified configuration for this interface, run the following
command to enable the interface:
npu(config-if)# no shutdown
Command
Syntax
npu(config)# interface {<interface-type> <interface-id>
|internal-mgmt |external-mgmt | bearer | local-mgmt | npu-host |
all-au}
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
internal-mgm
t
|external-mg
mt | bearer |
local-mgmt
Indicates the IP interface for
which the configuration mode
is to be enabled.
Mandatory N/A
 internal-mgm
t
 external-mg
mt
 bearer
 local-mgmt
Command
Modes
Global configuration mode