User Manual

Chapter 4 - Operation and Administration Using the CLI Managing AUs
4Motion 478 System Manual
4.5.6.2 Displaying Configuration for AU Control
To display configuration for the Control parameter of a specific or all AU objects,
run the following command:
npu# show control au [<(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>]
Specify the au slot ID (1-4, 7-9) if you want to display configuration information
for a particular AU. Do not specify a value for this parameter if you want to view
configuration information for all existing AU objects.
InstalledType The AU Type.
 threeDSP (1)
 twoDSP (2)
 other (3)
 auNotDetected (4)
InstalledPorts The number of ODU ports. two (1)
four (2)
other (3)
auNotDetected (4)
InstalledBandwidth(MHz) The bandwidth supported by the
AU.
fourteen (1)
twenty (2)
other (3)
auNotDetected (4)
HWVersion AU HW Version number <number>
HWRevision AU HW Revision number <number>
SerialNo. AU Serial number <number>
BootVersion AU Boot SW Version number <string>
IFVersion AU IF Version number <number>
IFRevision AU HW Revision number <number>
Command
Syntax
npu# show control au [<(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>]
Privilege
Level
1
Parameter Description Possible Values