User Manual

Chapter 4 - Operation and Administration Using the CLI Managing AUs
4Motion 473 System Manual
4.5.3.3 Restoring the Default Values of Connectivity Parameters
To restore Connectivity parameters do their default value, run the following
command:
npu(config-au-1)# no connectivity [maxframesize] [bearervlanid]
You can restore only one of the parameters to its default value by specifying only
that parameter. For example, to restore only the maximum frame size to the
default (1522), run the following command:
npu(config-au-1)# no connectivity maxframesize
The maximum frame size will be restored to its default value, while the
bearervlanid parameter will remain unchanged.
To restore both parameters to their default value, run the following command:
npu(config-au-1)# no connectivity
Command
Syntax
npu(config-au-1)# no control
Privilege
Level
10
Command
Modes
Global configuration mode
NOTE
Refer to Section 4.5.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-au-1)# no connectivity [maxframesize] [bearervlanid]
Privilege
Level
10
Command
Modes
au configuration mode