User Manual

Chapter 4 - Operation and Administration Using the CLI Managing AUs
4Motion 466 System Manual
If you use this command to create a new AU, the configuration mode for this AU is
automatically enabled, after which you can execute any of the following tasks:
 Configure one or more of the parameters tables of the AU (refer to
Section 4.5.2)
 Restore the default values of parameters in one or more of the parameters
tables of the AU (refer to Section 4.5.3)
After executing the above tasks, you can terminate the AU configuration mode
(refer to Section 4.5.4) and return to the global configuration mode.
4.5.2 Configuring AU Parameters
After enabling the AU configuration mode you can configure the following
parameters tables:
IMPORTANT
An error occurs if you specify an AU slot ID that is not in the range, 1-4, or 7-9.
Command
Syntax
npu (config)# au <(1 to 4 StepSize 1) | (7 to 9 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 4 StepSize
1) | (7 to 9
StepSize 1)>
The slot ID of the AU to be
configured
Mandatory N/A
 1-4
 7-9
Command
Modes
Global configuration mode
NOTE
The following examples are for au configuration mode for au-1 .