User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 462 System Manual
4.3.14.8 Configuring the Unique Identifier for the 4Motion Shelf
The Site Identifier (Site ID) is used by the management system as identifier of the
site and must be unique in the managed network.
The default value 0 is not a valid Site Identifier: it indicates that the Site Identifier
was not configured and a valid Site Identifier must be configured. A BTS with Site
Identifier 0 will not be discovered by AlvariSTAR.
Since the Site Identifier is used by AlvariSTAR to identify the site, it is highly
recommended not to modify it. If necessary, you must follow the Site Number
Change process described in the AlvariSTAR Device Manager User Manual.
To configure a unique identifier for the 4Motion shelf, run the following command:
npu(config)# site identifier <site id <0-999999>>
Command
Modes
Global configuration mode
NOTE
To display the 4Motion shelf identifer, refer to “Displaying the Unique Identifier for the
4Motion Shelf” on page 783
.
Command
Syntax
npu(config)# site identifier <
site id <0-999999>>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<
site id
<0-999999>
>
Indicates the ID of the
4Motion shelf.
Mandatory N/A 0-999999
Command
Modes
Global configuration mode