User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 460 System Manual
4.3.14.7 Configuring the Location Information for the 4Motion Shelf
The site location parameters provide general information on the site. Run the
following command to configure the 4Motion shelf location information, such as
the rack number and location:
npu(config)# site {Name <name (32)> | Address <address(32)> |
RackLocation <rack no. + position in rack (32)> | ContactPerson
<name (32)> | AsnName <name (32)> |Region <area (32)> |ProductType
BMAX_4M_Macro}
For example, run the following command if you want to specify the site name:
npu(config)# site name Site 12
[<alarm_num>] Denotes the alarm number of
the input or output alarm for
which configuration
information is to be displayed.
Refer
Figure 4-2 and
Figure 4-3 for more
information about the
numbers assigned to the pins
used for connecting dry
contact alarms.
Optional N/A
 1-8 for input
alarms
 1-3 for
output
alarms
Display
Format
Dry-Contact Input Alarm:
AlarmNumber AlarmName InputBlocking
<alarm num> <alarm name> <Yes or No>
Dry-Contact Output Alarm:
AlarmNumber AlarmStatus AlarmName
<alarm num> <On or Off> <name>
Command
Modes
Global command mode