User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 444 System Manual
4.3.14.2.8 Displaying GPS General Configuration Parameters
To display the GPS general configuration parameters, run the following command:
npu# show gps config [{ Type | SoftwareVersion [{ Navigation |
Signal }] | AdaptorRequired | HoldoverPassedTout |
HoldoverPassTxOperationStop | AlmanacUsableTime |
EphemerisUsableTime | IntervalToReadGPSTime | TimeToReadGPSTime} ]
Syntax
Description
For a detailed description of each parameter in this command, refer the section,
“Configuring
the GPS Clocks” on page 434
.
Both Current and Configured values for each clock are provided (the parameters are applied after
reset)
Display
Format
Configured External 1PPS Status :Enable/ Disable
Current External 1PPS Status :Enable/ Disable
Configured External 16MHz Status :Enable/ Disable
Current External 16MHz Status :Enable/ Disable
Command
Modes
Global command mode
Command
Syntax
npu# show gps config [{ Type | SoftwareVersion [{ Navigation | Signal }] |
AdaptorRequired | HoldoverPassedTout | HoldoverPassTxOperationStop |
AlmanacUsableTime | EphemerisUsableTime | IntervalToReadGPSTime |
TimeToReadGPSTime} ]
Privilege
Level
1
Syntax
Description
For a detailed description of each parameter in this command, refer the section,
“Configuring
General Configuration Parameters for the GPS” on page 437
.