User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 432 System Manual
4.3.14.1.2 Configuring the PIU Hardware Version
You need to manually configure the PIU hardware version that is currently in use.
The system periodically checks whether the configured and actual hardware
versions are identical. If there is a difference in the configured and actual
versions, an alarm is raised.
To configure the PIU hardware version, run the following command:
npu(config)# PIU <slot id (1-2)> hw_version <version (0-7)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
{PSU | PIU} Indicates whether the PSU or
PIU slot is to be enabled or
disabled.
Mandatory N/A
 PSU
 PIU
<slot id> Indicates the slot ID of the
PSU/PIU that you want to
enable or disable. Refer
Figure 4-1 for more
information about the slot ID
assigned to each PIU/PSU
module on the 4Motion
chassis.
Mandatory N/A
 1-4 for PSU
slot
 1-2 for PIU
slot
Command
Modes
Global configuration mode
Command
Syntax
npu(config)# PIU <slot id (1-2)> hw_version <version (0-7)>
Privilege
Level
10