User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 430 System Manual
 “Configuring the PSU/PIU Modules” on page 430
 “Configuring the GPS” on page 433
 “Managing Power Feeders Configuration” on page 447
 “Managing Dry-contact Input Alarms” on page 450
 “Managing Dry-contact Output Alarms” on page 455
 “Configuring the Location Information for the 4Motion Shelf” on page 460
 “Configuring the Unique Identifier for the 4Motion Shelf” on page 462
4.3.14.1 Configuring the PSU/PIU Modules
This section describes the commands to be used for:
 “Enabling/Disabling the PSU, and PIU Modules” on page 430
 “Configuring the PIU Hardware Version” on page 432
4.3.14.1.1 Enabling/Disabling the PSU, and PIU Modules
You can use the CLI to configure the administrative status of the PSU/PIU
modules to enable or disable.
Run the following command to enable/disable the PSU/PIU modules:
npu(config)# enable {PSU | PIU} <slot id>
npu(config)# disable {PSU | PIU} <slot id>
Specify the slot ID of the PSU or PIU to be enabled. The following figure depicts the
slot ID of the 4Motion shelf components:
IMPORTANT
An alarm is raised if you enable a PSU or PIU that is already powered down, or you disable a PSU
or PIU that is already powered up.