User Manual
Chapter 4 - Operation and Administration Using the CLI Using the Command Line Interface for 4Motion System
4Motion 129 System Manual
You can, at any time, return to your default privilege level. For details, refer
Section 4.1.5.3.2.
4.1.5.3.2 Returning to the Default Privilege Level
Run the following command to disable the current privilege level, and return to
your default privilege level:
npu(config)# disable [Level <0-15>]
After you run this command, you automatically return to your default privilege
level. You can display your current privilege level, using the following command:
npu# show privilege
NOTE
You can display your current privilege level, using the following command:
npu# show privilege
NOTE
An error may occur if:
You have specified an incorrect password. Remember that all passwords are case-sensitive.
No password is not configured for the privilege level you are trying to access.
Command
Syntax
npu(config)# enable [Level <0-15>]
Privilege
Level
0
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[Level <0-15>] Indicates the privilege level
you want to enable.
Mandatory N/A 0-15
Command
Modes
Global configuration mode